Archive

Posts Tagged ‘arp’

arp

July 7th, 2009

Table of Contents

NAME

arp – address resolution display and control

SYNOPSIS

arp [-n] hostname

arp [-n] -a

arp -d hostname

arp -s hostname ether_address [ temp ] [ pub ]

DESCRIPTION

The arp command displays and modifies the tables that the address resolution protocol uses to translate between Internet and Ethernet addresses.

With no flags, arp displays the current ARP entry for hostname. The host may be specified by name or by number, using Internet dot notation.

OPTIONS

-a
Displays all of the current ARP entries.

-d
Deletes an entry for the host called hostname.

-n
IP addresses are displayed instead of hostnames.

-s
Creates an ARP entry for the host called hostname with the Ethernet address ether_address. The Ethernet address is given as six hex bytes separated by colons. The entry not will be permanent if the words following -s includes the keyword temp. Temporary entries that consist of a complete Internet address and a matching Ethernet address are flushed from the arp table if they haven’t been referenced in the past 20 minutes. A permanent entry is not flushed.

If the words following -s include the keyword pub, the entry will be "published”; i.e., this system will act as an ARP server, responding to requests for hostname even though the host address is not its own.

CLUSTER CONSIDERATIONS

In takeover mode, each filer in a cluster maintains its own ARP table. You can make changes to the ARP table on the live filer, or your can make changes to the ARP table on the failed filer using the arp command in partner mode. However, the changes you make in partner mode are lost after a giveback.

VFILER CONSIDERATIONS

When run from a vfiler context, (e.g. via the vfiler run command), arp operates on the concerned vfiler. As currently all vfilers in an ipspace share an arp table, arp operates on the arp table of the concerned vfiler’s ipspace.

SEE ALSO

ifconfig , partner , ipspace , vfiler , RFC1483.


Table of Contents

7-mode Manual Pages , , , ,

arp

March 3rd, 2009

     arp [-d] [ip-address] [dest-address]

     Without any parameters, the arp command will display the contents of the
     arp table.  With two parameters, arp can be used to add permanent arp
     entries to the table (permanent arp entries do not time out)

     -d           Delete the specified ARP entry.  If specified, ip-address
                  may be * to delete all entries.

CFE / Loader Commands , , ,



This site is not affiliated or sponsored in anyway by NetApp or any other company mentioned within.