Table of Contents


rlm – commmands for use with a Remote LAN Module (RLM)


rlm help

rlm reboot

rlm setup

rlm status

rlm test autosupport

rlm test snmp

rlm update


The rlm command is used with a Remote LAN Module (RLM), if one is present. Using this command, you may get the status of an RLM and test an RLM. Configuration of an RLM can be performed by using the setup command.


Display a list of Remote LAN Module (RLM) commands.

Causes the RLM to reboot. If your console connection is through the RLM it will be dropped. The reboot command forces a Remote LAN Module (RLM) to reset itself and perform a self-test.

Interactively configure a Remote LAN Module (RLM).

Display the current status of a Remote LAN Module (RLM).

test autosupport Performs autosupport test on the Remote LAN Module (RLM). The autosupport test forces a Remote LAN Module (RLM) to send a test autosupport to all email addresses in the option list autosupport.to.

test snmp
Performs snmp test on the Remote LAN Module (RLM). The snmp test forces a Remote LAN Module (RLM) to send a test snmp trap to all traphosts set in snmp command snmp traphost.

The RLM firmware is updated. This may be a time consuming operation. Before issuing this command , you need to execute the `software install’ command to get the new firmware image. The RLM will be rebooted at the end of this operation.


This command only acts upon a Remote LAN Module (RLM) that is local to the system.


rlm status

might produce:

           Remote LAN Module           Status: Online                          Part Number:        110-00030                          Revision:           32                          Serial Number:      296167                          Firmware Version:   RLM_package_version=1.2.0                          Mgmt MAC Address:   00:A0:98:01:98:D0                          Using DHCP:         no                          IP Address:                          Netmask:                            Gateway:   


setup , options


Some of these commands might pause before completing while the Remote LAN
Module (RLM) is queried. This is normal behavior.

Table of Contents

Copyright © 1994-2008 NetApp, Inc. Legal Information

7-mode Manual Pages , , , ,

  1. No comments yet.
  1. No trackbacks yet.

This site is not affiliated or sponsored in anyway by NetApp or any other company mentioned within.
%d bloggers like this: